Search results

Hey Rob, I have 2 ph probes currently connected to my robotank. Is it possible to connect two conductivity probes? Also, let me know if this is an premature question, but how much will the stepper motor module cost? When can we order it? Thanks, Dilshan

Hey Rob. A little bit busy at the moment but I will test it when I get the chance. Thanks again

Hey Rob, any updates on the dosing. Cheers

Hey Rob, I want to connect a stepper motor that runs at a constant speed continuously. I am guessing this could be done outside the robo app. I can see you can do this via the db9 connector. This may be a very simple question but, how to run a code outside the robo app? How would you...

Hey Rob. This is the screen I have when I connect the HDMI. Do I need to enter a command. Thanks, Dilshan

Hi Rob. If I connect a non-touchscreen hdmi screen to the raspberry pi, will it work as a read only screen? Will it also allow me to access the Web page on a separate device to make changes? I want a screen on the front of the tank that just shows the main home screen but also a screen my kids...

With all the success of your latest release, bring on the salinity probe!!

Hey Rob. Yes it is. The calcium reactor is on manual but the other two are switching perfectly 👌

Have you placed the jumper leads for the ac bars on the main controller. These need to be placed before the ac bars work. You can also place a safety float switch if you want the backup.

Flow meter up and running. Very very good Rob! Cheers Dilshan

perfect :)

Ok all installed. where can I select flow sensor from the drop down. There does not seem to be an option. Thanks, Dilshan

ok will do

Do I need to do another fresh install again :)

oops yes i did

The tried to access Robo tank through the webpage and this happened

I Did a fresh install and at the end this happened

doing a fresh install :)

P.S in the interim, I think it tried to auto update prior to finishing the last few pre-update commands. I can access the site but it is not updating. Do I need to do a fresh install or once I get the pre-updates sorted it should still work?

Still an error and the first command above also threw up an error